What should I do if the trigger or handle is leaking?

If you are having an issue with the trigger or handle leaking, please follow the steps below to troubleshoot:

Ensure that the upholstery nozzle is properly seated to the trigger mechanism... if the head is not pushed all the way onto the trigger mechanism the short hose below the upholstery head can be pulled out of its fitting.

1. Remove the upholstery head.

2. Ensure that the short hose (with locking nut) is pushed back into place (retract the blue locking valve and reinsert the black hose)

3. Reattach the upholstery head while carefully lining up the locking number...ensure that the head is pushed all the way on and that the short hose is straight.

4. Twist and lock the locking nut onto the trigger mechanism.

Here is a video about how to reattach the upholstery head... it is very important that the short hose is not pulled out of the fitting.

If you are still experiencing the same issue even after following the steps above, send us an email with a video showing the specific problem you’re having at service@aquaprovac.com to assist you further.
Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us